Details
In-Sight Vision Suite 24.3.0 - IS3805M Emulator
Here you can find a zip file with:
- Two In-Sight .jobx (standard and reversed),
- One "Calibration_Grid" image without fiducial (.jpg) : to be used with the two .jobx (standard and reversed),
- One "CalibrateGrid" image with Fiducial (.bmp), which shows the orientation of the fiducial.
Here is the link : https://cognex-envision.my.salesforce.com/sfc/p/4W000003cdWO/a/Ue000000Wua9/PHhDWc1Z1nbW4qhk083NGIKzvaNMpVN2AKuQsfhs5Yw
With a "Calibrate" tool :
- "Standard" jobx for In-Sight Vision Suite : standard axis orientation (= opposite of the axis orientations with IS Explorer)
- X horizontal, left to right
- Y vertical, top to bottom
- "Reversed" jobx for In-Sight Vision Suite : reversed axis orientation (= similar to the axis orientations with IS Explorer)
- X vertical, top to bottom
- Y horizontal, left to right
For both jobx, the 4 points in pixels (cells A3 to B16), are always at the same position : there is no change compared to In-Sight Explorer :
- Point 0 : Top Left corner
- Point 1 : Top Right corner
- Point 2 : Bottom Left corner
- Point 3 : Bottom Right corner
For the 4 world points in mm (cells D3 to E16), the X and are all reversed.
The "Edit Point" (cell A21) is just used to test the job, the calibration, and the axis orientations.
The .jobx, and the calibrate grid (jpeg) can be loaded in In-Sight Vision Suite 24.3.0 (IS3805M Emulator) for testing purpose.
With a "CalibrateGrid" tool : the fiducial must have the orientation described on the attached picture "CalibrateGrid_Fiducial_10mm_Reverse_XY".
